Hi,
I am using an OWL CM180i but it reports all usage as 0W. Unfortunately I don't have the Owl Receiver so I am not able to confirm its working.
It uses 3 clamps but I am only on single phase here. I have tried various combinations of 1 - 3 clamps in the different ports but still the readings are Zero.
Does anyone have any advice? I am using the latest version of the CM180i
Thanks
OWL CM180i Reads 0W
Moderators: rtenklooster, Voyager, BertB, Stuntteam
Re: OWL CM180i Reads 0W
http://www.rflink.nl/blog2/download
make a debug log and mail that to me
make a debug log and mail that to me
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Re: OWL CM180i Reads 0W
I've emailed it over.
Thank you!
Thank you!
Who is online
Users browsing this forum: No registered users and 2 guests