RC522 RFID Tag Reading into Domoticz
Posted: 28 Jun 2022, 17:23
Hi,
I would like to use an RFID-RC522 Reader connected to a Wemo D1 mini (8266) running ESPEasy to transmit the recognized RFID.Tag-IDs to my Domoticz system.
I'm using this firmware: ESP_Easy_mega_20211105_test_C_ESP8266_4M1M
So far all is running well: Wenn approaching the reader with an RFID-TAG, it is shown in ESP-Easy's Log Windows correctly:
1075818: MFRC522: New Card Detected
1075821: MFRC522: Scanned PICC's UID
1075847: MFRC522: New Tag: 1834046931 card: MIFARE 1KB
1076142: MFRC522: New Tag: 0
However the Tag ID is not shown in ESP-Easy's Device-Tab (Tag is always Zero) .. see attached screenshot
Also no value is sent to the configured Domoticz controller, where I've set up a virtual device and entered the respective device IDX in ESP-Easy.
No Errors/Warnings/Hints in the Log.
What could be wrong here ?
I would like to use an RFID-RC522 Reader connected to a Wemo D1 mini (8266) running ESPEasy to transmit the recognized RFID.Tag-IDs to my Domoticz system.
I'm using this firmware: ESP_Easy_mega_20211105_test_C_ESP8266_4M1M
So far all is running well: Wenn approaching the reader with an RFID-TAG, it is shown in ESP-Easy's Log Windows correctly:
1075818: MFRC522: New Card Detected
1075821: MFRC522: Scanned PICC's UID
1075847: MFRC522: New Tag: 1834046931 card: MIFARE 1KB
1076142: MFRC522: New Tag: 0
However the Tag ID is not shown in ESP-Easy's Device-Tab (Tag is always Zero) .. see attached screenshot
Also no value is sent to the configured Domoticz controller, where I've set up a virtual device and entered the respective device IDX in ESP-Easy.
No Errors/Warnings/Hints in the Log.
What could be wrong here ?