RFLink: Unhandled log mode prints nothing, while scope image shows plenty of signals on the receiver's output
Posted: 23 Aug 2021, 21:43
Guys,
I'm newbie with RFLink, but hooked up with an Arduino, and I'm watching RFLink Loader V1.11 to see any RF signals around me.
In spite I have this on scope on GPIO19 of Arduino Mega2560:
and in spite I have enabled "Log mode: debug" and "Log mode: unhandled", there is nothing written to console.
Is this normal? Please note I just created a screenshot of my scope image, this signals are keep repeating (living in a dense area).
Shouldn't "unhandled" log mode print me all of these signals?
Please let me know what am I missing.
Thank you!
I'm newbie with RFLink, but hooked up with an Arduino, and I'm watching RFLink Loader V1.11 to see any RF signals around me.
In spite I have this on scope on GPIO19 of Arduino Mega2560:
and in spite I have enabled "Log mode: debug" and "Log mode: unhandled", there is nothing written to console.
Is this normal? Please note I just created a screenshot of my scope image, this signals are keep repeating (living in a dense area).
Shouldn't "unhandled" log mode print me all of these signals?
Please let me know what am I missing.
Thank you!