Page 1 of 1
Any one successfully using "Aldi" BBQ Sensor (ET923)?
Posted: 10 May 2021, 12:41
by padrino
Hi there,
I am using one of these... (see photo below)
Works reliable for me, unfortunatelly I can't get it recognized by rflink.
With the loader programm in debug mode it shows up like a charm... :-/
Anyone else maybe able to get it to work and I am just unlucky? =)
- GrillThermoAldi.jpg (189.93 KiB) Viewed 15613 times
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
Posted: 10 May 2021, 17:27
by Stuntteam
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
Posted: 10 May 2021, 20:03
by padrino
I know it's name is not on the list but as sometimes devices are supported under different names, that was my hope, too...
I also sent some debug output in 2019, but never received feedback, maybe my mails don't come thru.
So I thought about asking others, maybe I was too stupid...
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
Posted: 10 May 2021, 21:13
by Stuntteam
I will try to locate your mail...
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
Posted: 11 May 2021, 00:53
by padrino
Just noticed, there was already a mail in 2018.
I could re-send them, if that helps.
Btw, subjects are (ok, I must admit, they probably could have been more distinct
):
"New / improved device at 433mHz =)"
"RFLink with Renkforce - and "the" BBQ Thermometer"
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
Posted: 10 Jul 2021, 11:13
by padrino
Stuntteam wrote: ↑10 May 2021, 21:13
I will try to locate your mail...
Hi there,
where you able to locate my emails?
If not, just tell me how I can further help.
If needed I can also resend them. =)
Any other assistance needed? Just tell me.
Thanks for investigating.
Have a nice weekend,
padrino