I have a LED remote control which uses a CC2500, which I would like to control by my home automation.
So I build a RFLink shield with a (transistor?) level shifter and a CC2500.
Arduino pin D6 is pulled to GND.
I understand that this is neither Ansluta nor LivingColours protocol. But is there a way to add primitive support for this remote control?
Is there anything I'm doing wrong here?
Code: Select all
20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R48;
20;01;setAnsluta=ON;
10;version;
20;02;VER=1.1;REV=48;BUILD=04;
10;status;
20;03;STATUS;setRF433=ON;setNodoNRF=OFF;setMilight=OFF;setLivingColors=OFF;setAnsluta=ON;setGPIO=OFF;setBLE=OFF;setMysensors=OFF;
10;rfdebug=on;
20;04;RFDEBUG=ON;
10;rfudebug=on;
20;05;RFUDEBUG=ON;
10;setAnsluta=on;
20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R48;
20;01;setAnsluta=ON;
10;setLivingColors=on;
20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R48;
20;01;setLivingColors=ON;
Regards
Marco