Adding Visonic MCT-302 to Domoticz with RFLink
Posted: 17 Jan 2018, 11:27
Hi,
I installed the RFlink yesterday and tried if I could "see" the Visonic equipment wtih RFLink Loader, but without any success. Firmware R48 should support this type of devices.
When I connect the RFLink ro my Raspberry PI with Domoticz it connects well and in the logfile I see no errors but also no sigm of any communications.
I specific bought this RFLink because it claims to support Visonic devices.
Did anyone succeeded in connecting the RFLink868 with Visonic?
Hope for a lot of reactions,
Hans
I installed the RFlink yesterday and tried if I could "see" the Visonic equipment wtih RFLink Loader, but without any success. Firmware R48 should support this type of devices.
When I connect the RFLink ro my Raspberry PI with Domoticz it connects well and in the logfile I see no errors but also no sigm of any communications.
I specific bought this RFLink because it claims to support Visonic devices.
Did anyone succeeded in connecting the RFLink868 with Visonic?
Hope for a lot of reactions,
Hans