Basic instructions to get blinds connected to RFLink
Moderators: rtenklooster, Voyager, BertB, Stuntteam
Basic instructions to get blinds connected to RFLink
Recently I bought an RFlink module that was pre-assembled, and while it works fine with the basic stuff like Klik Aan Klik Uit I have no idea how to connect my blinds to it. Are there any instructions on connecting blinds that are supported? From reading the supported devices list on RFLink.nl my Faher Solar radio Bi-Directional motor should be supported (Or at least I hope). But apart from the mention on that page there's no documentation on how to actually begin pairing the RFlink to the motor itself.
Re: Basic instructions to get blinds connected to RFLink
This is a thread that I got regarding somfy blinds
viewtopic.php?t=3399
I am not sure whether your one is supported by rflink or not.
viewtopic.php?t=3399
I am not sure whether your one is supported by rflink or not.
Re: Basic instructions to get blinds connected to RFLink
It doesn't seem like it is supported tbh. I've tried all sorts of things to get anything to happen when I send the up / down commands but nothing. Also, I've tried following the steps on rflink.nl to provide debug data but whenever I turn debug mode on nothing actually shows up in the log? I tried pressing all the buttons on the remote and even reconnecting it but nothing. Does that maybe suggest the motors aren't using the 433mhz band to communicate with each other?
Re: Basic instructions to get blinds connected to RFLink
I think the bi-directional models are not supported yet..
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Who is online
Users browsing this forum: No registered users and 0 guests