first I enable SPI in hardware so I have this: SPI : CLK=18/ MISO=19 / MOSI=23
then I connect: SD_SCK=18, SD_DO=19; SD_DI=23
but i'm not sure where to connect other pin, for example the ACTUATOR (
GPIO → TFT CS:GPIO-14
GPIO → TFT DC:GPIO-27
GPIO → TFT RST:
)
in display ther is "SD_SS SD card SPI bus chip select signal, low level enable" and sounds like a DC, but also pins 3 and 4 seems good
do you have any idea?
thanks
(I will need to get the touch input, but this will be a next issue
![Erg Blij :D](./images/smilies/icon_e_biggrin.gif)