Good morning,
the duty cycle value used in the pwm command must be stored somewhere.
Is there a command to retrieve it?
read the duty cycle value?
Moderators: grovkillen, Stuntteam, TD-er
Re: read the duty cycle value?
Doesn't it show at the pin state buffer page?
Not sure if that page is also/already available as JSON.
Not sure if that page is also/already available as JSON.
Re: read the duty cycle value?
Thanks!
And is retrieving the value from there for further processing (sending it somewhere / rules) possible somehow?
Edit:
And is retrieving the value from there for further processing (sending it somewhere / rules) possible somehow?
Edit:
it isn’t ...Not sure if that page is also/already available as JSON.
Re: read the duty cycle value?
Not right now.
But I guess it would make sense to make it available, like the pinstate is.
For example:
See: https://espeasy.readthedocs.io/en/lates ... ing-events
Then scroll up a bit...
But I guess it would make sense to make it available, like the pinstate is.
For example:
Code: Select all
[Plugin#GPIO#Pinstate#13]
Then scroll up a bit...
Re: read the duty cycle value?
Have you made any progress? ->viewtopic.php?p=61989#p61989
Who is online
Users browsing this forum: No registered users and 89 guests