Hi there,
I am using one of these... (see photo below)
Works reliable for me, unfortunatelly I can't get it recognized by rflink.
With the loader programm in debug mode it shows up like a charm... :-/
Anyone else maybe able to get it to work and I am just unlucky? =)
Any one successfully using "Aldi" BBQ Sensor (ET923)?
Moderators: rtenklooster, Voyager, BertB, Stuntteam
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
It is not yet supported.
check http://www.rflink.nl/blog2/development
check http://www.rflink.nl/blog2/development
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
I know it's name is not on the list but as sometimes devices are supported under different names, that was my hope, too...
I also sent some debug output in 2019, but never received feedback, maybe my mails don't come thru.
So I thought about asking others, maybe I was too stupid...
I also sent some debug output in 2019, but never received feedback, maybe my mails don't come thru.
So I thought about asking others, maybe I was too stupid...
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
I will try to locate your mail...
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Re: Any one successfully using "Aldi" BBQ Sensor (ET923)?
Just noticed, there was already a mail in 2018.
I could re-send them, if that helps.
Btw, subjects are (ok, I must admit, they probably could have been more distinct ):
"New / improved device at 433mHz =)"
"RFLink with Renkforce - and "the" BBQ Thermometer"
Who is online
Users browsing this forum: Semrush [Bot] and 1 guest