Hi
I use a level control device
triggered by a switch - PIR.
Have a PIR attachted on D5 GPIO14
an Control switch listening for D5 switching D8 Gpio 15:
set level 1 hysteresis 0
But logic is inverse.
When PIR is 1 Level Control is 0 and vice versa.
Did I miss anything?
running v2- test-12
on Lolin Nodemcu
Thanks T
Log:
410209 : SW : State 1
410230 : EVENT: PIR#MOTION_PIR-d5-p14=1.00
410384 : LEVEL: State 0
410417 : EVENT: LC_PIR#ALERT_PIR=0.00
412001 : SW : State 0
412032 : EVENT: LED#LED-d8-p15=0.00
Level Control not working - invers?
Moderators: grovkillen, Stuntteam, TD-er
Re: Level Control not working - invers?
What type of PIR? Please give more info.
There are some PIRs in the wild that have an "open collecctor" output.
So if they trigger the output goes low.
Which rules do you use?
There are some PIRs in the wild that have an "open collecctor" output.
So if they trigger the output goes low.
Which rules do you use?
Regards
Shardan
Shardan
Who is online
Users browsing this forum: Bing [Bot] and 0 guests