Issue about Serial Server Device

Moderators: grovkillen, Stuntteam, TD-er

Post Reply
Message
Author
tdouez
Normal user
Posts: 5
Joined: 29 Jul 2021, 10:13

Issue about Serial Server Device

#1 Post by tdouez » 29 Jul 2021, 10:33

Hello,
I would like to test the serial connection between my PC with terminal and Telnet with a WEMOS D1 mini. It works by sending characters from Telnet to serial terminal but I get nothing when sending characters from serial terminal. :( Is there a particular configuration to set up in EspEasy?

PC Telnet -> WEMOS ESP -> PC USB Terminal : OK
PC USB Termnal -> WEMOS ESP -> PC Telnet : KO, no character received

My configuration :
1 - config.png
1 - device.png
1 - tools.png
1 - tools.png (29.18 KiB) Viewed 1289 times
Attachments
1 - device.png
1 - device.png (38.76 KiB) Viewed 1289 times
1 - config.png
1 - config.png (18.07 KiB) Viewed 1289 times

User avatar
Ath
Normal user
Posts: 1103
Joined: 10 Jun 2018, 12:06
Location: NL

Re: Issue about Serial Server Device

#2 Post by Ath » 29 Jul 2021, 12:15

You should disable the Serial Port checkbox on the Tools/Advanced screen, as it will conflict with the Serial Server device.
/Ton

tdouez
Normal user
Posts: 5
Joined: 29 Jul 2021, 10:13

Re: Issue about Serial Server Device

#3 Post by tdouez » 30 Jul 2021, 09:22

After disabled the serial port, i still have the same problem. :(
1.png
1.png (50.64 KiB) Viewed 1263 times

tdouez
Normal user
Posts: 5
Joined: 29 Jul 2021, 10:13

Re: Issue about Serial Server Device

#4 Post by tdouez » 30 Jul 2021, 14:54

i tried with an ESP32 and the last firmware without success.
I don't understand...

TD-er
Core team member
Posts: 5417
Joined: 01 Sep 2017, 22:13
Location: the Netherlands
Contact:

Re: Issue about Serial Server Device

#5 Post by TD-er » 30 Jul 2021, 15:27

What do you send to the ESP?
Do you end with CR (ASCII code 13) and/or LF (ASCII code 10) ?

Edit:
Is the baud rate set correct on both sides?

tdouez
Normal user
Posts: 5
Joined: 29 Jul 2021, 10:13

Re: Issue about Serial Server Device

#6 Post by tdouez » 30 Jul 2021, 16:55

Juste send test with ascii characters...
I use the Arduino terminal with CR/LF checked.
If I reset the serial interface, I received some logs in serial terminal and yet I deactivated the serial logs
1.png
1.png (87.64 KiB) Viewed 1243 times
2.png
2.png (102.54 KiB) Viewed 1243 times

Post Reply

Who is online

Users browsing this forum: No registered users and 31 guests