hello
can i trigger some kind of refresh in the rules for generic mqtt import?
After the daily reboot of the espeasy (esp32 / 20114 - Mega32) the data for the rule ( on mqttimport#value} will only be active when the value changes the first time.
can i somehow say in the rules that it fetches a complete new refresh from the mqtt server?
THX
refresh generic mqtt import
Moderators: grovkillen, Stuntteam, TD-er
Re: refresh generic mqtt import
Not sure I fully understand your question.
As the MQTT import is used in a task, the last values should be restored on a (warm) reboot.
So what you can do, is trigger the same event on which you trigger for new values.
As the MQTT import is used in a task, the last values should be restored on a (warm) reboot.
So what you can do, is trigger the same event on which you trigger for new values.
Code: Select all
on System#Boot do
event,mqttimport#value
endon
Re: refresh generic mqtt import
HMMM
ok I understand, but since I do not know the value that mqtt had transmitted (which is still on the mqtt server) , since I translate via mqtt the error message in text for an OLED, I am now somewhat at a loss how to proceed for 20 possible error messages.
ok I understand, but since I do not know the value that mqtt had transmitted (which is still on the mqtt server) , since I translate via mqtt the error message in text for an OLED, I am now somewhat at a loss how to proceed for 20 possible error messages.
Code: Select all
// ALARM MELDUNG
on LOGO3#cmdMQTT=0 do
oledframedcmd,1, " "
oledframedcmd,2, "[LOGO3#TempTeich]{D}C Wasser"
oledframedcmd,3, "[LOGO3#TempLuft]{D}C Luft"
endon
on LOGO3#cmdMQTT=99 do
oledframedcmd,1, "ALARM"
oledframedcmd,2, "Pumpenalarm"
oledframedcmd,3, "Pumpen prüfen"
endon
on LOGO3#cmdMQTT=98 do
oledframedcmd,1, "ALARM"
oledframedcmd,2, "Wasserstop 60 min"
oledframedcmd,3, "Reset Wasserstop"
endon
on LOGO3#cmdMQTT=97 do
oledframedcmd,1, "Aktion"
oledframedcmd,2, "TF Spuehlt"
oledframedcmd,3, " "
endon
on LOGO3#cmdMQTT=82 do
oledframedcmd,1, "ALARM"
oledframedcmd,2, "LOGO Verbindung down"
oledframedcmd,3, " "
endon
Who is online
Users browsing this forum: Google [Bot] and 22 guests