RFLink: Unhandled log mode prints nothing, while scope image shows plenty of signals on the receiver's output

Moderators: rtenklooster, Voyager, BertB, Stuntteam

Post Reply
Message
Author
danergo
New user
Posts: 2
Joined: 23 Aug 2021, 21:32

RFLink: Unhandled log mode prints nothing, while scope image shows plenty of signals on the receiver's output

#1 Post by danergo » 23 Aug 2021, 21:43

Guys,

I'm newbie with RFLink, but hooked up with an Arduino, and I'm watching RFLink Loader V1.11 to see any RF signals around me.
In spite I have this on scope on GPIO19 of Arduino Mega2560:

Image

and in spite I have enabled "Log mode: debug" and "Log mode: unhandled", there is nothing written to console.

Image


Is this normal? Please note I just created a screenshot of my scope image, this signals are keep repeating (living in a dense area).

Shouldn't "unhandled" log mode print me all of these signals?

Please let me know what am I missing.

Thank you!

User avatar
Stuntteam
Site Beheer
Posts: 787
Joined: 27 Jan 2016, 16:46

Re: RFLink: Unhandled log mode prints nothing, while scope image shows plenty of signals on the receiver's output

#2 Post by Stuntteam » 23 Aug 2021, 23:41

You can see pulses on a scope, but if these pulses do not provide a clean signal then it could just be noise and will not result in any debug data.
Also, do no use the unhandled mode, just use the debug mode.

What kind of RF module do you have?
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8

danergo
New user
Posts: 2
Joined: 23 Aug 2021, 21:32

Re: RFLink: Unhandled log mode prints nothing, while scope image shows plenty of signals on the receiver's output

#3 Post by danergo » 24 Aug 2021, 09:11

Thanks,

I got some pulses now on the console.

What is the difference between unhandled mode (on/off)?

My module is a 433.92MHz RR3 (I believe these are produced by Teleconrolli): I found its datasheet here: http://13.124.15.139/pdf/download.php?i ... 2520433.92

Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests