After testing, I see that the signals decoded by rflink are inconsistent (full details in attachment)
I am using RFLink v46:
Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R46;
VER=1.1;REV=46;BUILD=0c;
The kerui D026 has 2 switches;
- 1 reed/magnetic switch for door open/door close (this switch will send both open and close event)
- 1 tamper switch to notify if the device is removed from the door (this switch will only send tamper event)
- most signals are decoded as Eurodomest, but some as Mertik or EV1527
- Some signals are not decoded/recognized at all
- Device id: for some devices the device ID is inconsistent (some signals use ID1, some ID2 for the same device) (0a4d15 or 2a4d15) (0e1c35 or 2e1c35). Since in these cases only the first digit of the ID is different.... could this be a decoding issue? (when different Device IDs are used, also different switch IDs seem to get decoded)
- DoorOpen->Closed and DoorClosed->Open seem to use different switch IDs (00 vs 01) or (00,01 vs 03). Expected to see the same switch ID for both open>Closed and Closed>open events
included are:
- 6 scenarios:
- Door Closed>Door Open (tamper in)
- door Open>Door Closed (tamper in)
- Door Closed>Door Open (tamper OUT)
- door Open>Door Closed (tamper OUT)
- Tamper IN-> Tamper out (door closed)
- Tamper IN-> Tamper out (door open)
- 104 different signals from 4 devices; multiple signals for each scenario
- 7 of these signals not decoded/recognized
Scenario (A),
Condition (B),
Device(C),
Full Code (D) (this is the debug from RFLink loader)
Decoded data (E->)