Smotek7 wrote: ↑20 Oct 2023, 20:20 No, it is only attached to the original connector.
I think it was only drawn as pins.

OK thanks

OK thank you.
Do you have the référence of the display connector please?

Smotek7 wrote: ↑20 Oct 2023, 18:04 HW version 2, SD card accessible from below without disassembly.
NSP-SD.jpg

Very Nice job
Is it possible for you to share the PCB and schematics files ?

Thank you for the tip.
Too bad we can't do it via http / virtual serial port, as you already tried.

Ok thanks for the information

ok thank you

Yes I see the HMC5883L but I need a widest range for my tests.
I am trying to find out how I can implement the component code in the ESPEASY software, as a new component.
Thanks

Good morning, First of all I don't know if I'm in the right part of the forum to make this request, please move my message if necessary. I am looking to interface espeasy with an Infineon TLV493D type magnetic field sensor. Below is an example of code given on the site http://www.esp32learning.com/c...

ok thank's a lot for your answers and your help

It works, thanks again! And no worries about the translation problem (I often use the translator too). Two other follow-up questions: - Is it possible to transfer the files for the screen via Espeasy (Virtual COM port or other?) without having to disassemble everything. - How to detect and report vi...

OK I changed my configuration and now it seems to work. (I manage to modify some text).
Thank you
But the "dim=" command causes no change.

Smotek7 wrote: ↑18 Jul 2023, 08:09 Did you reboot?

There was an error "to" instead of "do" in the rule, I edited my post.

Do we have a magic formula? You need to create rules on system#boot to gpio,4.0 endon You can test the connection via the buzzer. IP/control?cmd=tone,21,1300,200 Buzzer is ok and just modify the rules and it works on system#boot do gpio,4.0 endon But always the same issue, when I writein chrome &qu...

Thanks to you both, I'll give it a try.

Hello I just bought an NSPANEL UK. I flashed it in "20230623 Display 4M" version. When I set the device, nothing works (while the screen works well under tasmota). Capture.PNG NB: I have unchecked the box concerning the serial in advanced setting. c1.PNG I checked with the Nextion software...