I could try desoldering the antenna - and then I would connect a wire directly from the pad to GND, correct?
I'd rather not doing anything irreversible though. Thanks for the suggestions, it's very much appreciated!
Search found 6 matches
- 28 Feb 2021, 22:57
- Forum: ESP Easy: Hardware
- Topic: Sonoff 4CH Pro R3 - random switching
- Replies: 15
- Views: 16505
- 28 Feb 2021, 14:07
- Forum: ESP Easy: Hardware
- Topic: Sonoff 4CH Pro R3 - random switching
- Replies: 15
- Views: 16505
Re: Sonoff 4CH Pro R3 - random switching
Well, this doesn't seem to be working for me. I've tried connecting a wire from the coil to the GND terminal where you would connect wires for flashing the board, and it make no difference. I also tried wrapping the coil in foil to try to screen it, in case the coil itself was insulated, but no chan...
- 22 Feb 2021, 18:48
- Forum: ESP Easy: Hardware
- Topic: Sonoff 4CH Pro R3 - random switching
- Replies: 15
- Views: 16505
Re: Sonoff 4CH Pro R3 - random switching
That's a good idea, and less irreversible than cutting a track which I suspect would lead me to cutting the wrong track!
Is the 433MHz antenna a copper spiral? Bottom-right in this image?
Is the 433MHz antenna a copper spiral? Bottom-right in this image?
- 22 Feb 2021, 16:46
- Forum: ESP Easy: Hardware
- Topic: Sonoff 4CH Pro R3 - random switching
- Replies: 15
- Views: 16505
Re: Sonoff 4CH Pro R3 - random switching
I have played around with debounce values, but it has no effect - and the random switching is happening by itself, not when I have just pressed a button. I saw another post on here about an R2 version of the 4CH box having similar problems, which it seems turned out to be "KAKU" or "C...
- 21 Feb 2021, 23:14
- Forum: ESP Easy: Hardware
- Topic: Sonoff 4CH Pro R3 - random switching
- Replies: 15
- Views: 16505
Sonoff 4CH Pro R3 - random switching
I bought a 4CH Pro R3, and flashed it successfully, setting it up so each of the 4 buttons controls the relevant relay. It all works fine except that buttons 3 and 4 seem to trigger on and off randomly (as well as working normally), triggering relays 3 & 4 respectively. I have a suspicion it may...
- 09 Oct 2020, 21:58
- Forum: RFLink: Unsupported devices
- Topic: Visonic Power Max 868Mhz
- Replies: 6
- Views: 13103
Re: Visonic Power Max 868Mhz
Has there been any progress in supporting Visonic 868MHz devices?
I bought my RFLink believing Visonic were already supported, but it seems not.
It would be really great if these devices could be supported.
I bought my RFLink believing Visonic were already supported, but it seems not.
It would be really great if these devices could be supported.