Search found 6 matches
- 18 Dec 2019, 21:39
- Forum: RFLink: Nederlands support forum
- Topic: RFlink/NodeMCU doet ineens vreemd
- Replies: 1
- Views: 28745
Re: RFlink/NodeMCU doet ineens vreemd
En ineens is het weer weg... Ik hoop dat het weg BLIJFT!
- 18 Dec 2019, 20:29
- Forum: RFLink: Nederlands support forum
- Topic: RFlink/NodeMCU doet ineens vreemd
- Replies: 1
- Views: 28745
RFlink/NodeMCU doet ineens vreemd
Na een geruime tijd normaal gewerkt te hebben, doet mijn RFLINK/NodeMCU gateway ineens vreemd. Hij reageerde eerder vanavond niet meer op signalen van mijn KAKU schakelaars, en in de log van Domoticz staat regelmatig een timeout/herstart combo. Ook heel vreemd is dat ik ineens met vlagen enorm veel ...
- 28 Jul 2019, 19:17
- Forum: RFLink: Unsupported devices
- Topic: KTNNKG anyone?
- Replies: 0
- Views: 34497
KTNNKG anyone?
Does anyone have any experience with KTNNKG 433MHz devices? Esp. whether they work with the RFlink?
- 21 Jun 2019, 14:18
- Forum: RFlink: General Discussions
- Topic: X10Secure support question
- Replies: 3
- Views: 32806
Re: X10Secure support question
I believe there is. That would be very nice, so I guess me not seeing them as devices is a Domoticz issue then rather than an RFlink one? >If so, can I also SEND Yes. >If so, can I also simulate X10 security sensors? Yes. >If NOT, is this something that could be added? Yes. Ok, guess I will need to...
- 21 Jun 2019, 12:49
- Forum: RFlink: General Discussions
- Topic: Serial issues?
- Replies: 5
- Views: 12956
Re: Serial issues?
I had the same issue and found out that only ONE serial port can be active at any time if you want to send signals. You can have both active if you want to monitor only, but if you want to control stuff, you have to choose between using the USB Serial or the Ser2Net connection on the WiFi. (As far a...
- 21 Jun 2019, 12:45
- Forum: RFlink: General Discussions
- Topic: X10Secure support question
- Replies: 3
- Views: 32806
X10Secure support question
I just wanted to check whether the X10Secure support in the RFlink firmware includes the X10/Marmitek security remotes (that are used for arm/disarm/panic)? If so, can I also SEND (as I cannot find X10Secure in the protocol reference at all) these commands? If so, can I also simulate X10 security se...