You Sir are a Genius, Thank you so so much, All working and happy now. I also discovered my cause, i was trying to use the wrong I2C pins as they are available and the drop down lets you select them. However i have discovered that doing so corrupts the esp..... I have tried this since i cleared the ...

Hope someone has an answer as seem to have some issues here and i have no idea what the problem is ?

in serial monitor i get this :

ets Jan 8 2013,rst cause:2, boot mode:(3,6)

load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
v614f7c32
~ld

Any help appreciated
Regards
Neil

By adding 1, 2, 3 after the word security..... Works fine now.... Thanks for the reply, Updated to latest firmware as recommended. Exactly the same....... My rules are as follows : On Security#DoorSensor6 do If [Security#DoorSensor6]=0 Publish Landing/Security/DoorSensor6,CLOSED Else Publish Landin...

What GPIOs are you connecting these switches to? Are the switches behaving okay, as in are they 1 on high and 0 on low etc? GPIO 0 GPIO 4 GPIO 5 They are switches 1 2 3 in the device list and all show one and zero as expected when switch pressed, but the mqtt message on two of the switches is alway...

Hi Guys, This is driving me insane ! I have three switch inputs, all pulled high by a 10k resistor. If taken low they should publish an MQTT message to openhab. They are all set up the same with a different message. Only one works ? The rules are as follows : On Security#DoorSensor6 do If [Security#...

sorry to be pain could you give me an example ? Ive spent ages trawling thru the rules an cant figure it out, it looks like openhab needs to see OPEN and CLOSED instead of 1 or 0 I have also tried the map file on openhab to no avail. if i send a message from MQTTFX with OPEN or CLOSED its works fine...

Many thanks for your speedy reply,

Could you elaborate for me ?
As i say im new to espeasy and an example would help very much

Kind Regards
Neil

Hi all, I am pretty new to this and i have an openhab system up and running after many hours of trial and error. I have installed espeasy(mega) on all of my sensors and all works well. The issue i'm having is using switch inputs, i have figured out that the esp device sends a 1 or a 0 and what i nee...