This is very unfortunate but real life comes first. I hope you can solve the issues you ran into, and we see you again on the forum.

ªU
PID:0
Version:0
INIT : Incorrect PID or version!
SD�S«¹Ñ�failed
ªU
PID:0
Version:0
INIT : Incorrect PID or version!

this is what i get when looking to a serial log

frank wrote:the MAX6675 arrived from hong kong. But it isn't working. How do i connect it to an esp8266 12e devkit the cs is at gpio 15

I had some time and have got it working. It works great. Now i am going to try mutiple TK on the esp.

It works with 2 TK

i have got my 2560 and networkshield. The software is uploaded with the rf link software. But when i put it in my network it doesnot get an ip adres the lights ar blinking but no respons. Is there a way to test it so i can find out what is wrong?

the MAX6675 arrived from hong kong. But it isn't working. How do i connect it to an esp8266 12e devkit the cs is at gpio 15

i have orderd an 2560 and network shield to test and work with this option. Muchmore IO so it is verry interesting

i just updatet to version 146 it seems to work fine. The question i have is after rebooting the unit automaticly goes back to the update screen. Is it possible to make a go back to the main screen button in the update screen? Or make it go back to the main screen after reboot

yes you should use the same udp PORT in every unit

This is different from bug #01 where it would never work because of a design issue. Sometimes the NTP server does not reply, but in my network this is a rare condition. I'll see if a simple retry mechanism can be implemented to avoid failure on a single missed packet... Listed as bug #10, intermitt...

For a project i am building i want to display the setpoint i set in domoticz on the lcd display that i have on my esp. Is that possible and can someone tel me how?

this is great. But for a noob like me how do you put the plug in in the software? (i found out already )

I am building an controller based on this for my BBQ. I have orderd the max6675.

I don't know if this is the right place for it but the new setup for http://www.letscontrolit.com/index.php/Main_Page is not working properly. The wiki link doesnot work.

MLX90614 on adres 0x5a is not shown in rc 141 scanner

Thanks that is the trick

this is the line i have done

Dome: [MLX90614#Temperature IR]C

But is does not work

I am trying to set the temperature from the Temperature IR + ambient - MLX90614 on the display but i can't get it working. I think it is the code in the line i have to put in. But i don't know the code.