Difference between revisions of "PMSx003"
Jump to navigation
Jump to search
Line 5: | Line 5: | ||
The following modules share the same interface: | The following modules share the same interface: | ||
* PMS3003 | * PMS3003 | ||
+ | TBD | ||
* PMS5003 | * PMS5003 | ||
+ | TBD | ||
* PMS7003 | * PMS7003 | ||
− | |||
[[File:Pms7003-front-view.png]] | [[File:Pms7003-front-view.png]] | ||
− | |||
* PMSA003 | * PMSA003 | ||
+ | TBD | ||
Pins: | Pins: |
Revision as of 10:07, 4 June 2017
Introduction
The Plantower PMSx003 modules are laser particle sensors. Particles are measured by blowing air through the enclosure. By measuring diffusion of the laser beam, the amount of particles is counted. Measurement information is transmitted over a serial interface.
Hardware
The following modules share the same interface:
- PMS3003
TBD
- PMS5003
TBD
- PMS7003
- PMSA003
TBD
Pins:
VCC - 5V (for fan and internal logic) GND - Ground (Note that chassis is also ground) RX/TX - 3V3 UART 9600 8N1 Set - Standby function, when pulled down the module does not send information over serial and goes into a low power state. Reset - Reset the module, similar to power-up, it takes ~30 seconds before data is received
Software
ESP Easy
Input
Output
References: PMS5003 english manual